![]() ![]() However, some customers think that this approach makes the drawing appear too busy, plus they don't want to flip back from sheet 7 to sheet 5 to see what terminal the wire came from. This is what I call "Design Reality", because it accuraely reflects what I really want the panel shop to do. I normally connect a second wire to TB1:5 and use a source/destination arrow combination to connect to the circuit on sheet 7. This of course is not what the customer was expecting. However, when you open Terminal Strip Editor, you will see two terminals labeled TB1:5, and your BOM will have an increased quantity reflecting the additional terminal number 5. If you override the software and change the 6 to a 5 the drawing will look the way you wish. This is normally great, but in this case you want to connect to the other side of TB1:5. If you insert a terminal on sheet 7 it will automatically index up to number 6. But the circuit that you wat to connect to the other side is on sheet 7. The other side of the terminal is still available, and you could even connect a second wire to the same side. ![]() For example, you have terminal TB1:5 on sheet 5 and you connect one wire to it, for a branch circuit. Some customers like to show the same terminal 2, 3, or 4 times throughout their schematic for clarity.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |